editor
Rookie Solder Flinger
Posts: 2
Likes: 0
|
Post by editor on Dec 29, 2006 12:20:52 GMT -5
(I've posted this on another board but I'm in a rush to finish the wiring -- gotta gig Sunday night !)
I'm rewiring my Strat Wannabee Mark II for the 38th time (hmmmm ... not much wood left to rout) & just want to be sure before the solder flows. Could someone point me to a site or post a pic (I'm pitiful when it comes to schematics) of what-goes-where from the pickup to the DPDT switch? Just a simple pic/diagram of 1 pickup to DPDT would be fine. I can take it from there.
The setup:
neck - Dimarzio humbucker (want to split) middle - Dimarzio humbucker (want to split) bridge - No-Name humbucker (not split) 5-way switch volume pot (no tone pot)
The Dimarzio's have red, white, black, green & ground (bare) wires.
|
|
|
Post by vonFrenchie on Jan 2, 2007 21:13:10 GMT -5
Would you want something like this 1: Neck full 2: Neck single/middle single 3: middle full 4: Middle single/bridge 5: bridge
|
|