|
Post by frets on May 27, 2019 16:47:53 GMT -5
Dear Gutar Nutz2,
I have a lovely 50’s style Jimmy Page style harness that won’t let go of its volume. I built the harness. I trust that I have made an error in the wiring given: 1.) with ALL knobs turned to off position....still have volume. I have tied each knob tone & vol. in different combinations to make sure they are not in wrong positions but in all cases volume is constant.
2.) Volumes do not have gradual increase when turning knob rather stays basically same volume till towards end of turn where the volume increases rapidly. T
Any help would be greatly appreciated. Thank you !
|
|
|
Post by thetragichero on May 27, 2019 23:13:47 GMT -5
hello,
do you have a schematic/layout that you used, along with some good clear pictures of your wiring job? posting those would be the first step(s) to us helping to troubleshoot your issue
|
|
Deleted
Deleted Member
Posts: 0
Likes:
|
Post by Deleted on May 29, 2019 5:37:51 GMT -5
Just to make sure wiring up the Volume Knob Correct
|
|
|
Post by newey on May 29, 2019 11:35:31 GMT -5
Do you still have volume if only one pickup is selected and the volume turned to "0"? Are the tone controls at full on when this happens? My thought was that the behavior may be a consequence of the '50's wiring. JohnH's "Modern vs. 50's wiring"
|
|