Seymour Vintage Rails (SVR-1N)

[mightyabacus]

hello friends.

i know its been asked so many times here but i honestly
couldn't find a single link that says how to do it
correctly.

for the Seymour Duncan SVR-1N Vintage rails, how do i
"correctly" install it to my Ibanez RG350DX White???

The stock INF3S has only 2 wires (1 to the switch and 1
to the pot ground) while the SVR-1N has 5 wires
(BLACK,WHITE,GREEN,RED and Ground).

Kindly advice how to connect it correctly.

Thank you.

[Mike Richardson]

If you have the instructions that came with the pickup, just follow them. If not, here's how it's done: Black goes to the selector switch. Red and White are soldered together and taped up. Green and the Bare wire go to ground. There is a chance that this will be out of phase. If the pickup doesn't sound right when it's on with another pickup, that's your problem. To fix it, just solder the Green wire to the switch, and the Black and Bare wires to ground.

[mightyabacus]

Thanks Mike!

That really helped alot.
No out of phase whatsoever.

The SVR-1N sounded very good in pure clean tone
and when I added a little gain, I get a Clapton-ish sound to it.


Here's the photo after the install:



The Seymour Duncan Vintage Rails SVR-1N




After the installation




Another shot at the pick-ups.




Full Frontal Shot