azazel
Rookie Solder Flinger
Posts: 4
Likes: 0
|
Post by azazel on Aug 28, 2023 5:03:00 GMT -5
Hey everyone I NEED HELP im trying to wire a 2 way DPDT switch that will activate two single coils in either in series or Prrl and one bridge humbucker on the other side with one vol pot!! Please get at me if yall can help im new and have only been wiring for a few months!! TY
|
|
xweto
Rookie Solder Flinger
Posts: 17
Likes: 0
|
Post by xweto on Aug 28, 2023 5:35:17 GMT -5
Are you using a 5-way switch? Could you specify a little more what you would want in every position?
|
|
azazel
Rookie Solder Flinger
Posts: 4
Likes: 0
|
Post by azazel on Aug 29, 2023 21:13:12 GMT -5
No 5 way switch
I want to have the two single coils on one side and the bridge on the other side
I have volume
HSS
ONE DPDT SWITCH
|
|
azazel
Rookie Solder Flinger
Posts: 4
Likes: 0
|
Post by azazel on Aug 29, 2023 21:14:17 GMT -5
No 5 way switch I want to have the two single coils on one side and the bridge on the other side I have volume HSS ONE DPDT SWITCH I know its probably stupid simple but im a dumbass newbie and am tired of having to rip out my wiring hahaha |
|
xweto
Rookie Solder Flinger
Posts: 17
Likes: 0
|
Post by xweto on Aug 30, 2023 3:45:00 GMT -5
Okay, I made a diagram. Im relatively new to this so maybe wait until somebody else verifies it. It does the following: Dpdt up : single 1 + single 2 (parallel) Dpdt down : HB (series)  |
|
azazel
Rookie Solder Flinger
Posts: 4
Likes: 0
|
Post by azazel on Aug 30, 2023 4:23:33 GMT -5
Sweet as it stands now before the mod i have the humbucked wired to the volume and output jack i have the red and white soldered together and tapped off im about to try and follow your diagram
Thank you!!
|
|
|
|
Post by newey on Aug 30, 2023 4:56:22 GMT -5
azazel- xweto's diagram does as he says it will. But you originally said you wanted: xweto's scheme just has the 2 single coils in parallel, not in series. But you couldn't get series/parallel switching of the single coil pickups, plus switching the HB, with just a DPDT switch anyway, as the series/parallel switching requires both poles of the DPDT in itself. You would need an extra DPDT switch to add the series/parallel.
|
|
