bajaman
Rookie Solder Flinger
Posts: 3
Likes: 0
|
Post by bajaman on Apr 11, 2022 0:52:29 GMT -5
Hi Antigua You didn't happen to measure the inductance in split mode by chance ? cheers bajaman
|
|
bajaman
Rookie Solder Flinger
Posts: 3
Likes: 0
|
Post by bajaman on Feb 21, 2022 18:39:59 GMT -5
excellent work - I too have been experimenting with ferrites and neodynium magnets using a sidewinder design and .04mm copper wire - the limiting factor is the curvature of the strat pickup cover - i had to use 12 2mm diameter neo rods set up like a fender jazz pickup separated by 1mm - initial results are very promising - i used 6000 turns on each coil and stuffed 11 cut off 2.8mm diameter steel nails in each coil to bring the inductance up to 2.6H - the neo rods are 10mm long and so the nails contact the mid point which is neutral magnetically. cheers bajaman
|
|
bajaman
Rookie Solder Flinger
Posts: 3
Likes: 0
|
Post by bajaman on Aug 15, 2021 17:06:47 GMT -5
Measured inductance, with an LCR meter, is measured at 100kHz I think you meant measured capacitance ?
|
|