Adding a Push/Pull tone pot for coil-split of neck humbucker

[yaser]

Hello there!

A little while back my old selector switch gave out and I decided I'd like to go ahead and make some mods to the wiring when I get around to replacing it.
I've perused this forum a few times while looking for a suitable diagram for the wiring I want to achieve, however it unfortunately proved fruitless.
So since I'm rather clueless when it comes to figuring out how to make the diagram myself - I'd like to ask for some assistance.
I've already got the new pot and a 5-way super switch available for use in this project.

The desired wiring should be attached below unless I somehow mess up while posting. ;-:
I'm also attaching a picture of a diagram from DiMarzio which should achieve the wiring before integrating push/pull pot. (to my understanding at least)
It has been corrected to use Seymour Duncan colour coding as that's the brand of pickups in the guitar.

Any help with incorporating the pot into it/helping make a brand new diagram would be greatly appreciated!
    

[newey]

yaser-

Hello and Welcome to G-Nutz2!

I think this can be done with the switching you have, but we'll have to work up a diagram which may take some time. I'm tied up with work at the moment but someone else may be able to jumpo on this sooner than I can. The scheme looks fairly similar to other schemes we have seen for two HBs, so we may be able to start from an existing similar scheme and make the changes from there.

[yaser]

Alright, that's great to hear!

I'm not in the biggest rush so I don't mind having to wait a while.
And thanks for taking the time to take a look at this!