jorg
Apprentice Shielder
Posts: 29
Likes: 0
|
Post by jorg on Oct 29, 2007 14:24:57 GMT -5
|
|
darguitar
Apprentice Shielder
Posts: 29
Likes: 0
|
Post by darguitar on Oct 29, 2007 17:26:49 GMT -5
I recently had a customer have me install a complete Tone Pros Stop Tail Piece/Bridge system on his Epiphone LP Black Beauty. I personally think that their products are excellent, and using this hardware means quicker string changes, and not having to fine tune the action so often.
Unfortunately for my customer, the existing studs on his guitar (for both tailpiece and bridge) were of a larger diameter than the Tone Pros studs. However, the threaded parts screwed right into the existing factory studs and the day was saved!
On a side note, if I hadn't the Stewmac knob/bushing puller tool, I would've been at this job for a LOT longer than nescessary!
Dar
|
|
jorg
Apprentice Shielder
Posts: 29
Likes: 0
|
Post by jorg on Oct 29, 2007 20:45:47 GMT -5
I was hoping to only use the screw in portions for the tailpiece myself. I don't want to pull the inserts. These are made for gibson style tailpieces and I believe the slots in mine (1982 Aria Pro II PE-R60) are smaller. I know the spacing is different so replacing the tailpiece is out. I don't have a problem with the guitar, I just thought these were a cool idea.
|
|
