First attempt at custom wiring, is it right?

[jetmeck]

Hello all,
Found this site a few days ago and it has definitely been a blessing. I found Mike Richardson's diagram (v 2.0) and it is just what i was looking for. So I drew up my own diagram adding a 2PDT to split the neck and bridge, and also added a kill switch.

I think I have it right but was wondering if some of the much more knowledgeable folks here could take a look to verify.

Being the simpleton I am I drew it as looking at the back of the guitar.

As Mike Richardson's v2.0 it should give me

pos  dwn    up
1     N     All 3 series
2     N+M   M>N
3     M     B>m+N
4     M+B   B>m
5     B     All 3 parallel

Again this is a great site and thanks for all your help.

[newey]

Jetmeck-

Hello and Welcome!

Someone who can check your diagram will be along shortly. In the meantime, if you can reduce the size of your image a bit it would be helpful. You're just a bit wide, but having to scroll horizontally makes it hard to see the whole thing at once.

A minor point, we're glad you posted. The Mike Richardson scheme gets a lot of attention here, and rightly so, it's a good one.

[jetmeck]

Thanks Newey,
I was excited when I got the picture to post in the first place (not to experienced with these new fangled typin' machines). Hopefully I have it adjusted better.

[ChrisK]

It looks fine.

You don't need to short both the output jack tip and the pickups in "kill". Just the signal at the jack tip will do (SPST).

I didn't check the MR wiring, that's your responsibility.

[jetmeck]

Thanks ChrisK,
I'm sure I copied MR's design correctly. I just wanted to make sure I was making all the other connections needed. "The Big Picture". I can see where a simple SPST would be all thats needed for the kill also. Thanks again.