|
Post by dannyhill on Jul 7, 2013 5:13:58 GMT -5
Hi guys,
I'm looking to wire up a black beauty copy with a 6 (free) way switch, triple shots and 4 pushpulls and optional back cover slide switches for maximal tonality! CUrrently thinking, B, B+N, N / B+M, B+M+N, M+N from the six way, this would be pup coils in parallel, series, slug or coil for each of B, M and N independently with the triple shots. Thereafter I would like reverse the phase on the neck and bridge pup outputs, should be easy enough with a couple of p/ps. What about switching between parallel and series connections between pups? Can this be done from just two p/ps for all combos of parallel and series between pups? Anyone know of an existing diagram? Of course on the back, on the cavity covers I can add 3 DP3Ts for tamers/HOOP/strangle switches (none, 0.01uF, xUF) for each pup and a DP3T for tone cap switching (0.033, 0.022, 0.01) Cheers,
Danny
|
|
|
Post by JohnH on Jul 7, 2013 15:27:54 GMT -5
well good luck with that!
On the use of two pp switches for series parallel. No doubt they could do a lot, but there are only 4 overall combinations out of tthe positions of two pp switches, so they couldnt do all such possibilities for an HHH set up.
I put some slide sitches on the rear switch cover, and they work fine, for things not used too often. I was not wanting them on the main cover however, in case they got knocked while playing. Maybe ok if they are recessed enough, using washers to let them set back so the switch is hardly protruding.
|
|