Deleted
Deleted Member
Posts: 0
Likes:
|
Post by Deleted on Mar 23, 2022 16:03:47 GMT -5
I am after a Potentiometer 120/150K I think the size is called 17mm Dual if you can would be a delightful but worse case single
Unless anyone know how I could make one , IE a wafer with a resistance of 120/150K
Best I can find is 100K and at a push 200K , I'd sooner not double up 250K to make a 125K
|
|
|
Post by newey on Mar 23, 2022 18:06:05 GMT -5
|
|
|
Post by thetragichero on Mar 29, 2022 7:49:03 GMT -5
|
|
Deleted
Deleted Member
Posts: 0
Likes:
|
Post by Deleted on Mar 29, 2022 12:54:10 GMT -5
dosnt intrest me .. after a 17mm 120/150K Pot because i want to make a 2nd wafer to fit with it so even if i hope to do 250K and join them so to make it 125K but i lose my second wafer so no good for me .. unless i get a QUAD POT, but im not keen on playing with them as i like to put the system on a Push/Pull so i need only two wafers one for the POT and one to help it with some kind of switching system ---------------------------------------------------------- I'm currently trying to design a 3 Bit Switch that attaches to a Pot so i can have Two systems in one I like the 3Bit because it will let you pick between 3 Pickups and it only needs 2 Tracks
|
|
|
Post by thetragichero on Mar 29, 2022 14:28:14 GMT -5
parallel resistor on outside lugs so you can get your intended value doesn't interest you? weird
|
|
|
Post by JohnH on Mar 29, 2022 16:21:27 GMT -5
Depends on what's most important about hitting those values. A parallel resistor between outer lugs of 390k gets close to the overall target using a 250k pot, may bdhave as a higher value at mid turn. Or, two of them, one between each outer lug to the inner lug hits the target at min or max rotation and produces about 190k overall at mid position. Taper is also affected though.
Or, if you can disassemble (tricky with duals), I'd expect you could scape a 100k track to get it up to 120k.
|
|
Deleted
Deleted Member
Posts: 0
Likes:
|
Post by Deleted on Apr 1, 2022 13:19:43 GMT -5
Two 250K means I use both wafers I wanted to use the second wafer
100K might be too small I don't really want to go too far below 125K
I think my only hope is 250K pot With 220K between lug1&2 and 220K between Lug2&3
|
|
Deleted
Deleted Member
Posts: 0
Likes:
|
Post by Deleted on Apr 17, 2022 5:54:19 GMT -5
|
|